Various Topics on Printers

02-25-2004

Hello, thanks in advance for reading this! I was replacing the printer
actuator modules on my Genicom 4440 but something is wrong. I get them all
lined up and tightened down, but I can't move the striker bar. If I remove
(or loosen) the far left module I can move the striker bar again, but of
curse that won't work. Is there something I'm missing here? Any help is
appreciated - thanks!

Mike

02-25-2004	#1
.... ..st..	Genicom 4440 printer - striker bar problem Hello, thanks in advance for reading this! I was replacing the printer actuator modules on my Genicom 4440 but something is wrong. I get them all lined up and tightened down, but I can't move the striker bar. If I remove (or loosen) the far left module I can move the striker bar again, but of curse that won't work. Is there something I'm missing here? Any help is appreciated - thanks! Mike

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode